Swift Talk Forums HERE

challenger 570 fridge

This forum is now closed to new posts but remains here as a source of information. New actictivity has transferred to the Swift Talk forums (see link above).

The views expressed here are those of the individual contributors and are not necessarily those of the Club.

challenger 570 fridge

Postby caravanman1 » November 13th, 2009, 11:04 am

hi ya too all
my 570 challenger fridge has a gap between work top and top of fridge is this right ,if not what should be there.
thanks
swift challenger 570 shogun 3.2 DiD
caravanman1
Members
 
Posts: 6
Joined: November 13th, 2009, 6:55 am
Location: linconshire

Re: challenger 570 fridge

Postby Giles » November 13th, 2009, 12:08 pm

You don't say how big the gap is but anything more than 5mm may need investigation by your dealer. Attached is a crop from a photo I took of a Challenger 570 at one of the shows. It's not brilliant but you can see the fridge installation. If your looks very similar there may be nothing to worry about. If not you should talk to your supplying dealer.
Attachments
c570.jpg
Giles
Members
 
Posts: 27
Joined: June 25th, 2007, 4:02 pm

Re: challenger 570 fridge

Postby caravanman1 » November 13th, 2009, 5:52 pm

thanks very much for your reply and picture mine looks about same,just lets a draught through.
swift challenger 570 shogun 3.2 DiD
caravanman1
Members
 
Posts: 6
Joined: November 13th, 2009, 6:55 am
Location: linconshire

Re: challenger 570 fridge

Postby metz » November 13th, 2009, 9:03 pm

Hi, should'nt be letting a draught through, may be the fridge has been out at some point and the sealing kit not installed correctly, best bet to get your dealer to check it out.
What go'es around comes around
metz
Members
 
Posts: 20
Joined: November 11th, 2008, 9:57 pm
Location: Skegness

Re: challenger 570 fridge

Postby charles » November 14th, 2009, 10:23 am

Even with good sealing it is still possible to get some draught around a fridge if there is a strong wind blowing onto that side of the van. This is because it is not easy to get a 100% room seal. If you experience draughts in other conditions then I agree with Metz that you should get your dealer to check it out.
User avatar
charles
Members
 
Posts: 88
Joined: February 10th, 2007, 6:25 pm


Return to Technical

Who is online

Users browsing this forum: No registered users and 1 guest

cron